Silvercrest SPS 3 A1 - Connecting the Microphone

GB
│
MT
│
51 ■
SPS 3 A1
NOTE
► When you connect your headphones, the speakers
2 are
muted and the audio signals are only routed through the
headphone socket
3.
► The headphone socket
3 is passive, i.e. it is possible to
adjust the volume using the ON/OFF
|
VOL knob
4, but
the maximum volume is set by the computer or playback
device. Please note that headphones may only be connect-
ed if the output from the playback device complies with the
required normative limits. For more information, refer to the
instruction manual of the playback device.
D
Connecting the microphone
NOTE
► Depending on the computer hardware/software you are
using, you may need to set up the microphone socket in
your computer's system settings before using it. Please refer
to the manual for your computer hardware/software for
more information.
♦ Make sure that the ON/OFF
|
VOL knob
4 is in the OFF
position.
♦ Plug the 3.5 mm jack plug of the microphone into the micro-
phone socket
5.
♦ Before turning on the microphone, turn on the soundbar
again.
♦ Turn on the microphone and carefully increase the volume.
IB_339086_SPS3A1_LB5.indb 51 16.01.20 17:00