Silvercrest SPS 3 A1 - Switching On;Off and Adjusting the Volume; Switching the LED Lights On;Off; Connecting Headphones

■ 50
│
GB
│
MT
SPS 3 A1
Switching on/off and adjusting the volume
♦ Turn the ON/OFF
|
VOL knob 4 clockwise to turn on
the device. The operating LED 6 lights up as soon as the
device is switched on.
♦ Turn the ON/OFF
|
VOL knob
4 further clockwise to
increase the volume.
♦ Turn the ON/OFF
|
VOL knob
4 anticlockwise to de-
crease the volume.
♦ Turn the ON/OFF
|
VOL knob
4 anticlockwise to turn off
the device. The operating LED 6 goes out as soon as the
device is switched off.
Switching the LED lights on/off
NOTE
The LED lights 1 are not suitable for lighting rooms in
houses.
♦ Set the LED ON / OFF switch
7 to the ON position to
switch on the LED lights
1.
♦ Set the LED ON / OFF switch
7 to the OFF position to
switch off the LED lights
1.
Connecting headphones
DANGER
Loud music can lead to hearing damage!
► Avoid extremely loud sound levels, especially
over long periods of time, when you are using
headphones.
♦ Make sure that the ON/OFF
|
VOL knob
4 is in the OFF
position.
♦ Plug the 3.5 mm jack plug of the headphones into the
headphone socket
3.
♦ Before putting on the headphones, turn on the speakers
2
again and carefully increase the volume.
IB_339086_SPS3A1_LB5.indb 50 16.01.20 17:00