Silvercrest SRR 3.7 D3 - Shaving with mains voltage; Trimmer;long hair trimmer

GB
│
IE
│
11 ■
SRR 3.7 D3
Note
► The best results are achieved if used on dry skin.
► It can take 2 to 3 weeks until the skin is accustomed to the dry
shaving system.
4) Move the shaving heads with straight and circular motions over
the skin.
5) After you have covered all the areas you want to shave, use the
On/Off switch
6 again to turn off the appliance. The blue
control lamp 7 goes out.
6) Clean the shaver after every use with the supplied brush e. For a
more thorough cleaning, read the section Cleaning and care.
Shaving with mains voltage
ATTENTON!
► This appliance is not suitable for wet shaving!
If you want to use the shaver without previously charging it, you can
also use it directly with mains voltage:
1) Plug the connector w into the mains connection 0 on the shaver.
2) Plug the mains adapter
q into a mains socket that complies
with the appliance specifications. While the battery is charging,
the red charge indicator light 8 flashes.
You can then use the shaver as described in the section Cordless
shaving.
Trimmer/long hair trimmer
To shape your beard or form sideburns, use the long hair trimmer 4.
1) To do this, push the catch
5 towards the long hair trimmer 4.
The long hair trimmer 4 flips out.