Silvercrest SRR 3.7 D3 - Cleaning and care; DANGER! ELECTRIC SHOCK!; ATTENTION! (Cleaning agents); Cleaning with the brush

■ 12
│
GB
│
IE SRR 3.7 D3
2) Press the On/Off switch 6. The shaver starts the cutting unit 2
and the long hair trimmer 4, the blue control lamp 7 lights
up.
3) Once you have finished trimming, press the On/Off switch
6
again to turn off the appliance. The blue control lamp 7
goes out.
4) Clean the long hair trimmer
4 with the supplied brush e. For a
more thorough cleaning, read the section Cleaning and care.
Cleaning and care
DANGER! ELECTRIC SHOCK!
► Before cleaning the device, disconnect the mains adapter q from
the mains power socket! There is a risk of electric shock!
ATTENTON!
► Do not use abrasive, chemical or caustic cleaning agents to
clean this appliance. This will irreparably damage the appliance.
Cleaning with the brush
Cutting unit
Clean the 3 shaving heads of the cutting unit 2 after every shave
using the brush e.
1) Take hold of the cutting unit 2 with three fingers in the grip
recesses 3 and pull it off.
2) Tap the cutting unit
2 on a flat surface or blow off the hair cuttings.
3) Use the brush e to remove any remaining hair cuttings.
4) Replace the cutting unit 2 flush on the appliance. Ensure that it
snaps into place and is seated firmly.