Silvercrest SRR 3.7 D3 - Reassembly of cutting unit; Note on replacement

■ 16
│
GB
│
IE SRR 3.7 D3
– Place the three shaving heads in the recesses of the cutting
unit
2. Ensure that the notches on the edge of the shaving
heads rest on the catches in the opening.
– Place the round blades into the shaving heads with the
blade tips to the front.
– Press the two tabs of the retainers together and place them
back into the catches of the cutting unit 2 and release the
tabs.
The cutting unit
2 is now reassembled.
5) Remove loose hairs from the shaver with the brush e.
6) Replace the cutting unit 2 on the shaver. Ensure that it snaps
into place and is seated firmly.
7) Clean the housing with a moist cloth.
Note
► If...
– ... the shaving result is noticeably poorer, ...
– ... you have to the shave the same spot repeatedly
to achieve a good result, ...
– ... the shave takes much longer than usual, ...
– ... there is visible damage to the shaving heads, ...
... the shaving heads/the cutting unit
2 must be replaced.
► You can order the cutting unit
2, incl. shaving heads from our
customer service (see section Ordering spare parts).
► To replace the cutting unit 2 proceed as follows:
1) Take hold of the cutting unit
2 with three fingers in the grip
recesses
3 and pull it off.
2) Fit the new cutting unit
2 onto the shaver. Ensure that it
snaps into place and is seated firmly.