SSM 550 D1
■ 8
│
GB
│
CY
Operation
NOTE
The motor switches off automatically as soon as the blender attachment is
removed from the motor unit . In such cases it may be easy to forget that the
machine is still switched on. The motor will then start unexpectedly as soon as
the blender attachment is fitted.
Therefore:
1) Do not plug in the appliance until the blender attachment is filled,
closed and fitted on the appliance.
2) Before fitting, always ensure that the appliance is switched off or the plug
has been removed.
3) Switch off first, pull the plug out and wait until the motor has come to a
standstill before removing the blender attachment .
Fitting and filling the blender attachment
1) Remove the blender attachment from the motor unit and remove the lid .
2) Fill the blender attachment and then press down the lid firmly onto the
blender attachment . Ensure that the pouring spout of the blender attach-
ment is also closed.
3) Place the measuring cap in the opening in the lid and close it by turning it
clockwise.
4) Place the filled and closed blender attachment on the motor unit . Turn
the blender attachment slightly until you can press it down. The motor
cannot start until the blender attachment is fitted flush.
Selecting the speed setting
Once the blender attachment is filled and sitting completely closed on the
motor unit , you can switch on the appliance:
Set the switch to...
– Level 1–3: liquid or semi-liquid foods, for mixing, pureeing and stirring.
– Level 3–5: for more solid foods or for chopping.
– Level Ice Crush/Clean: for short, powerful pulse operation, e.g. for
crushing ice cubes or cleaning. To prevent overloading the motor, the
switch will not click into place in this setting. Therefore, hold the
speed switch in this position only for short periods.
To Next Page
Loading...
