SSM 550 D1
■ 14
│
GB
│
CY
If you clean the blender directly after use, you will usually achieve suitably
hygienic cleaning results by using the following method:
1) Fill the blender attachment with 750 ml of water and add a drop of wash-
ing up liquid. Close the lid and place the blender attachment onto the
motor unit .
2) Plug in the appliance and activate Ice Crush/Clean a couple of times so that
the cutting blades plough through the water at maximum speed.
3) Afterwards, rinse the blender attachment with plenty of clear water to
remove any washing up liquid residues.
If this does not remove the dirt, you
can remove the lower plastic part of the
blender attachment with the cutting
blades from the glass part of the
blender attachment :
Glass part
Sealing ring
Cutting blade
Plastic part
4) Remove the blender attachment
from the motor unit .
5) Turn the plastic part
of the blender
attachment anticlockwise so that it
can be removed from the glass part
of the blender attachment .
WARNING –
RISK OF INJURY!
► Treat the cutting blades
/ with
great care. They are extremely sharp!
Risk of injury!
6) Clean both parts in a mild soap solu-
tion or in the dishwasher.
7) Re-attach the plastic part
of the
blender attachment to the glass part
of the blender attachment . Make
sure the sealing ring is inserted.
To Next Page
Loading...
