EasyManua.ls Logo

Silvercrest SSMP 900 A1 - Operation Guide; Understanding Blade Uses; Preparing Food for Blending; Mixing and Chopping Process

Silvercrest SSMP 900 A1
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
GB
Use the blade assembly with a flat blade8
for chopping solid food (e. g. nuts).
NOTE:
with an operating time of approx.
8-10 seconds, use no more than 50 g when
chopping nuts.
6.2 Preparing food
WARNING! Risk of material damage!
~ Thick or firm peels, (e.g. of citrus fruits,
pineapple), stems and pips of stone
fruits (e.g. cherries, peaches, apricots)
must be removed before blending.
Rinse or wash the fruits.
Cut the fruit into rough pieces (approx.
3-4 cm edge length).
For smoothies: use a sufficient amount
of liquid (mineral water, juice, milk, yo-
ghurt). We recommend a mixing ratio
of 1:1.
6.3 Mixing/Chopping
CAUTION: mind the marking MAX for the
maximum filling quantity.
NOTE: if the smoothie is too thick, add a lit-
tle mineral water, fruit juice, milk or yoghurt
to suit your taste.
1. Connect the mains plug4 with the wall
socket.
2. Place the fruit pieces and any other in-
gredients into the blender jug5/6 as
desired. Mind the marking MAX for
the maximum filling quantity.
3.
Figure A:
screw the required blade as-
sembly
7
/
8
onto the blender jug
5
/
6
.
Ensure that the blade assembly is tightly
screwed to the blender jug.
4. Figure B: turn the blender jug5/6
around and place it on the base unit1.
The small noses11 on the edge of the
blender jug fit into the recesses at the
head of the base unit1.
5. A slight clockwise turn of the blender
jug5/6 switches the device on.
Let the device run for no more than
60seconds.
6. A slight anticlockwise turn of the blend-
er jug5/6 switches the device off.
Wait until the blade7/8 has come to a
standstill.
7. Remove the blender jug5/6 from the
base unit1 and turn it around.
8. Unscrew the blade assembly7/8 and
ensure that the liquid drips into the
blender jug5/6.
9. Before using it again and if necessary,
rinse the blade assembly7/8 briefly
under running water.
10. Disconnect the mains plug4 from the
wall socket.
11. Clean the device as soon as possible
after use.
6.4 Drink immediately
Figure C: in order to drink the fresh
smoothie directly from the blender
jug5/6, place the ring10 on the edge
of the blender jug5/6. This is more
pleasant because the thread of the
blender jug5/6 will thus not come in
contact with your lips. Both rings fit onto
all blender jugs5/6.
Remove it by simply pulling the ring10
off upwards.
BB&3(B%ERRN6HLWH)UHLWDJ0lU]

Table of Contents

Related product manuals