SilverCrest STLK 8 D2
English - 37
8. Before you start
Check the air cooler and the accessories for damage. If the air cooler is damaged, do not use it.
9. Getting started
Place the air cooler on a flat, stable surface (e.g. a table). When you carry it, use the fold-out handle
(5).
CAUTION! If the device is faulty or used incorrectly (too much liquid added), water can leak
out of the bottom of the device.
CAUTION! If there is no water in the water reservoir (13), the air cooler can be switched on
using the on/off button (2), but only works as a fan (i.e. it will not cool the air). The light
effects can still be set using the mood light button (4).
The parts of the air cooler can be taken apart and put back together without tools. So it is easy to refill
and clean the air cooler.
Wet the new air filter (11) completely under cold, running water before putting it into operation. This
ensures optimum cooling effect from the start.
9.1 Filling/refilling the water reservoir
WARNING! The water reservoir (13) must be emptied, cleaned and refilled after 72 hours at most.
Micro-organisms present in the water or the area where the air cooler is used or stored can grow in
the water reservoir (13) and be emitted into the air, which can lead to serious health risks if the
water is not replaced and the water reservoir (13) properly cleaned every 72 hours.
How to fill the water reservoir (13):
1. Press slightly with your finger on the top of the closure flap of the front panel (1). This allows it to be
detached from the housing.
2. Now pull the water reservoir (13) with the air filter (11) inserted carefully forwards out of the housing
(12).
3. Lift the air filter (11) up out of the water reservoir (13).
4. Fill the water reservoir (13) with water. For the device to work
properly, there must be between 300 ml and 700 ml water in
the reservoir. Keep an eye on the fill level display (9) on the
side of the water reservoir (13), see the arrow in the diagram
opposite.
To Next Page
Loading...
