GB
│
MT
│
77 ■
SV 125 C5
NOTE
► The bag opening must lie flat on the welding wire 4. Otherwise the weld-
ing does not work properly.
4) Close the appliance lid 1. The press seal q presses the bag onto the welding
wire 4, to create a smooth seam. Ensure that both corners of the appliance
lid 1 click closed. If necessary, press them down once again on the markings
and so that the appliance lid 1 clicks into place and locks shut.
5) Press the
button w. The control lamp w lights up. As soon as the sealing
process is completed, the control lamp w flashes briefly and then goes out.
NOTE
► You can halt the sealing process at any time by pressing the
button w
again. The control lamp w flashes and then goes out.
To Next Page
Loading...
