GB
│
MT
│
83 ■
SV 125 C5
Vacuum sealing containers
1) Connect the vacuum hose u onto the suction fitting
9 of the appliance.
2) Select the appropriate adapter i/o/p for the container you want to
vacuum and attach it to the vacuum hose u.
3) Close the appliance lid 1. Ensure that both corners of the appliance lid 1
click closed. If necessary, press them down once again on the markings
and
so that the appliance lid 1 clicks into place and locks shut.
4) Connect the adapter i/o/p to the appropriate fitting on the container.
Please refer to the instruction manual of the container for further information.
5) Press the
button
z. The control lamp z lights up and the appliance
sucks the air out of the container. As soon as all the air is sucked out, the
control lamp z goes out.
6) You can now remove the adapters i/o/p from the container and the
appliance.
Cleaning
DANGER
Risk of fatal injury from electrocution!
► Remove the plug from the mains power socket before beginning to clean
the device.
► Ensure that no moisture can penetrate the device during cleaning.
CAUTION
Possible damage to the appliance.
► Do not use aggressive or abrasive cleaning agents, as these may corrode
the surface of the casing.
► Do not use any hard or sharp objects to remove any adhesive from the
welding wire 4. Otherwise the welding wire 4 or the insulation could
be damaged.
Cleaning the appliance
♦ Clean the surface of the housing of the appliance with a lightly moistened
cloth and a mild detergent.
♦ Wipe off the upper 0 and the lower sealing rings 5, as well as the press
seal q with a damp cloth. Ensure that the appliance is dry before using it again.
♦ Wipe the vacuum hoses u, and the adapters i/o/p with a damp cloth. If
there is heavy soiling, you can also clean these parts in hot water with a little
detergent. Ensure that all components are completely dry before the next
use.
To Next Page
Loading...
Need help?
General
