■ 10
│
GB
│
IE
SV 125 C6
NOTE
► The bag opening must lie flat on the sealing wire 4. Otherwise the weld-
ing does not work properly.
4) Close the appliance lid 1. The press seal q presses the bag onto the
sealing wire 4 to create a smooth seam. Ensure that both corners of the
appliance lid 1 click closed. If necessary, press them down once again on
the markings
and so that the appliance lid 1 clicks into place and
locks shut.
5) Press the
button w. The control lamp w lights up. As soon as the sealing
process is completed, the control lamp w flashes briefly and then goes out.
NOTE
► You can halt the sealing process at any time by pressing the
button w
again. The control lamp w flashes and then goes out.
To Next Page
Loading...
