SimCom SIM7000G At Command Manual

Smart Machine Smart Decision
SIM7000 Series_AT Command Manual_V1.03 147 2018-05-08
if <mode>=4
+CIPRXGET: 4,<id>,<cnflength>
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameters
<mode>
0
Disable getting data from network manually, the module is
set to normal mode, data will be pushed to TE directly.
1 Enable getting data from network manually.
2 The module can get data, but the length of output
data can
not exceed 1460 bytes at a time.
3 Similar to mode 2, but in HEX mode, which means the
module can get 730 bytes maximum at a time.
4 Query how many data are not read with a given ID.
<id> A numeric parameter which indicates the connection number
<reqlength> Requested number of data bytes (1-1460 bytes)to be read.
If <mode>=4,the range of <reqlength> is 0-2920bytes.
<cnflength> Confirmed number of data bytes to be read, which may be less
than <length>. 0 indicates that no data can be read.
Parameter Saving
Mode
NO_SAVE
Max Response
Time
-
Reference Note
To enable this function, parameter <mode> must be set to 1 before
connection.
8.2.28 AT+CIPRDTIMER Set Remote Delay Timer
AT+CIPRDTIMER Set Remote Delay Timer
Test Command
AT+CIPRDTIM
ER=?
Response
+CIPRDTIMER: (100-4000),(100-7000)
OK
Parameters
See Write Command
Read Command
AT+CIPRDTIM
ER?
Response
+CIPRDTIMER: <rdsigtimer>,<rdmuxtimer>
OK
SIMCOM COMFIDENTIAL FILE

SimCom SIM7000G Specifications

General

Brand	SimCom
Model	SIM7000G
Category	Control Unit
Language	English