SDM630 DMR TIER II – OPERATING INSTRUCTIONS
© SimocoGroup Australasia 2013 page 22 TNM-U-E-0108 Issue 1.1
4.2.7 Alert Volume
This Screen allows you to set the level of the relative Alert Volume level in relation to the
current Volume setting. The level can be set in 33 steps over the range 0 to 32, with 0 being
about the same as the voice level.
From the Settings Sub Menu, step through the menu options with the ▼ and ▲ keys until the
Alert menu is displayed.
Press the “OK” key for the “Alert Volume” adjustment screen
Use the ▼ and ▲ keys to change the relative alert volume level. The beep will sound at the
indicated level each time the setting is changed.
Press “OK” to accept the setting and return to the Channel Screen.
Pressing the “Menu” key will exit back to the setup menu.
Note: A minimum Alert Level may be set by the FPP to ensure that the Alerts can always be
heard from the speaker.
To Next Page
Loading...
