Step 2. Check the Performance of the AV Receiver's Audio Output as Shown
in Fig 3-23
Step 1. Purchase a 6.35mm to 3.5mm Adapter and Set up as Shown in
Fig 3-22
SM-828D1 / SM-828D2 is not compatible with ANY RCA(L/R) ports on your AV
Receiver, ONLY use the BIG 6.35mm PHONE OUT on front side of your AV
Receiver with the 6.35mm to 3.5mm adapter (purchase separately).
Fig 3-23
AV Receiver
6.35mm Audio adapter
(purchase separately)
3.5mm Audio Cable
6.35mm Phone jack
Pho nes
94dB
85dB
75dB
volume
L
4. Use Two Sets of SIMOLIO 2.4GHz Wireless TV Earphones
Simultaneously in the Same House
• earphone
transmitter, then turn on the transmitter
and earphone and make sure the green
LED indicators are facing towards each
other for about 5 seconds.
Take the close to the
Note: If two are used on the
same TV, only one transmitter needs to
be connected, because one transmitter
supports multiple earphones to work
simultaneously.
earphones
5. Charge the Earphone
Method 1:Turn off the earphone and place it onto the magnetic charging stand
for recharging, the LED charging indicator on the stand will stay solid red while
charging and turn green when charging is complete. (Ref. Fig 5-1)
• The two sets of SIMOLIO SM-828D1 / SM-828D2 should be put at least 10 meters
away from each other when using them simultaneously.
room 1
room 2
Transmitter 1
Fig 4-1
Distance >10M (at least)
Transmitter 2
Step 2. If you can not hear sound from your after connecting,
follow the part of 3.1 on page 8-9 to check your settings.
earphones
3) Use SIMOLIO SM-828D1 / SM-828D2 to your AV Receiver with 6.35mm
PHONE jack
Note: When you just want to listen to the audio from the wireless TV earphone,
just turn off your sound system.
Pho nes
AV Receiver
6.35mm Audio adapter
(purchase separately)
3.5mm Audio Cable
6.35mm Phone jack
Fig 3-22
POW
E
R
D
C 5V
A
U
X
S
TER
EO / MO
NO / O
F
F
OPTI CAL
OPTI CAL
A
UX
I
N
O
UT
ON / OF
F
A
U
X IN
Transmitter
Fig 3-21
Sound Bar
PO
W
E
R
DC 5
V
AUX
ST
E
RE
O / MO
N
O / OF
F
OPT
I
C
A
L
OPT
I
C
A
L
AU
X
I
N
OU
T
ON / OFF
If you can not hear sound from your headsets after connecting:
• Use the 6.35 to 3.5mm converter to plug a wired headphone/earphone into the
port on AV receiver to check whether the sound is normal. (Ref. Fig 3-22)
14 15
SM-828D1/SM-828D2 SM-828D1/SM-828D2
OPTICAL OUT
OPTICAL IN
RCA or 3.5mm Audio Out
H/P
Audio Out
RCA or 3.5mm Audio In
+ VOL -
L
R
Power adapter
(Transmitter)
P
owe
r &
W
ork
i
ng
I
ndi
cato
r (
Gr
ee
n
)
Fig 4-2
( )Earphone
Wireless Receiving
Indicator (Green)
L
+ VOL -
R
L
To Next Page
Loading...
