1
The following instructions are very important to safe operation of gas appliance. Please read through them
carefully. Please contact Towngas Company on 2880 6988 for enquiry and services.
Installation
1. Use approved gas tubing bearing EMSD approval marking (such as: 機電工程署批准 EMSD APPROVAL
GTXXXX) for connection to appliance or other appropriate methods accepted by EMSD.
2. Fix the gas governor (ELITRE, EL-125). Ensure that the pressure setting is 1.0kPa.
3. When installing gas appliance on top of kitchen cabinet, check that the air-intake opening at top plate (if
applicable) is not blocked in order to ensure proper operation of the gas appliance.
4. Install the gas appliance in a well-ventilated room.
5. Do not store any flammable materials, sprays or pressurized containers inside the stove cabinet below
appliance.
Operation
1. In case of suspected gas leak, open windows and shut off gas meter valve. Do not operate any electric
appliances or switches. Do not use any phones on site. Contact Towngas Emergency Hotline on 2880
6999 with a phone outside the premises.
2. Please use the appliance properly according to the operating instructions.
3. This appliance is designed for domestic use only. Do not use it for commercial purposes.
4. Do not use appliance for any purposes other than cooking, e.g. drying clothes.
5. Open windows and turn on ventilation system before operating the appliance.
6. Do not allow kids to use appliance.
7. Do not leave operating appliance unattended.
8. Do not add aluminum discs to burners. This will incur combustion problem.
9. Ensure that burner cap and burner body are not deformed. Contact Towngas Company to replace the
parts if deformation is found.
10. Before use, ensure the burner cap, burner body and pan supports are in correct position and are not
tilted.
11. Ensure that flame holes of burners are free from water and dirt.
12. Do not put weight exceeding 10kg on each pan support.
13. Pan support is heavy. Do not drop it.
14. Do not press the rotary knob for more than 10 seconds. If the burner is not ignited after 10 seconds, wait
at least 1 minute before making further attempt.
15. Make sure that flame condition is uniform during operation.
16. Heed high temperature of top plate, burners and pan supports.
17. Do not use flat bottom utensil with too large diameter to avoid the risk of scald by high temperature and
reduce the service life of the appliance. When using small utensil, reduce flame power that flame does
not escape from utensil bottom.
18. Ensure stability of utensil resting on pan support. Hold utensil firmly if it slips easily.
19. Top plate is fixed. Do not remove it.
Important Safety Instructions
Burner
Maximum Diameter of Flat Bottom Utensil
(mm)
Left Burner 280
Right Burner 280
To Next Page
Loading...