Wireless Communication Locator Quick Start Guide
Focus on Precise Space-time, Assist in Smart Service Worldwide
Used to test if the gyroscope is functioning
properly
If a gyroscope trigger is detected, the gyroscope
will be cleared
Prompt if the gyroscope is not detected to be
triggered
(General testing will be done by shaking the
locator a few times and clicking once)
Another: If it does not shake, it also continues to
display the gyroscope triggered, then it is
abnormal
4 Set the privacy time
directly
With the above command, set the privacy time to
20:00-22:00
5. Check the privacy time
privacy time
6. Query the reporting server
Reply null when server is not set
7. Configure the reporting
server
The AT + SIMPLEIPW = 8.135.32.130:9999
Set the IP and port of the reporting server as
above
Empty the escalation server when
"AT+SIMPLEIPW=" is sent
8. Query the current firmware
version
To Next Page
Loading...