Simple S1 - Server Data Monitoring; Accessing Locator Data via Server

Wireless Communication Locator Quick Start Guide
Focus on Precise Space-time, Assist in Smart Service Worldwide
5
will turn toMode 2
automatically
immediately for 3 seconds
Mode 2: Idle mode
Shaking will trigger the gyroscope,
will switch to mode 1 after reported
---
Click once to activate, then press
immediately for 3 seconds
After the report completed, the
current time is privacy time
Press for 6 seconds, still will turn
to Mode 5 after reset
Mode 3: SOS mode
Click Activate, then press
immediately for 3 seconds
---
Press for 6 seconds, still will turn
to Mode 3 after reset
After the report completed, the
current time is privacy time
Only after exit the SOS mode,
can the device be off
Mode 4: Privacy mode
---
Exit from the private time slot,
will turn to Mode 2
automatically
Click once to activate, then press
immediately for 3 seconds
---
Press for 6 seconds, still will turn
to Mode 5 after reset
Mode 5: Off mode
Press for 6 seconds, when it’s on
will turn mode 1

---
Click once to activate, then press
immediately for 3 seconds
---
---
※ During the S1 locator in sleep state, if do not press 3 seconds to switch mode immediately after activating,
it will be judged as a mistouch and it will continue to be sleep.
Server address: http://ebike.xbteek.com/login
If the S1 locator is not disconnected within a short period of time after it is reported, you can view the current
position of the S1 locator through real-time monitoring.