Wireless Communication Locator Quick Start Guide
Focus on Precise Space-time, Assist in Smart Service Worldwide
The mode switch key allows you to change the positioning reporting interval and switch the device on or off
The Micro-USB interface is used for debugging and charging
The soft rubber plug on the outside to prevent dust and water stains
The slots on the both external sides of the locator can be used to fix the locator with the backpack strap/pet
collar/small wristband
※ Please use the NB dedicated IoT card in the SIM card slot
※ Start after inserting the card, or sleep without the card
The core function of S1 wireless communication locator is to report its position information to the server at
different frequencies according to different modes.
This locator has a 5 modes in total, respectively:
Mode1: Working mode (high frequency reporting position data, once every 5 minutes by default)
Mode2: Idle mode (low frequency reporting position data, once every 10 minutes by default)
Mode3:SOS mode (UHF continuous reporting of position data, once every 3 minutes by default)
Mode4: Privacy mode (in the preset privacy time, no position data can be reported)
Mode5: Off mode
The S1 locator can automatically switch between Mode2 idle mode and Mode1 working mode, depending on
whether it is currently moving.
When the time you go out, pick it up and go, without any additional operations required, the S1
locator will automatically switch from Mode2 idle mode to Mode1 working mode to improve the
reporting frequency.
When you go home, it can automatically switch from Mode1 working mode to Mode2 idle mode when you
put down the S1 locator, can also reduce the reporting frequency to save power, reduce charging frequency,
and satisfy the use experience.
When you encounter danger or need ultra-high frequency(UHF) reporting outside, tap the key to release, and
then press immediately for three seconds, and then SOS mode is opened. At the same time, the ultra-high
frequency positioning information will be reported, and continue to connect with the server. When connecting to
the third-party server, the server can initiate the query of positioning data at any time in this mode.
The privacy mode time period can be preset by connecting the computer, and will not be reported
during this time period to protect the privacy of customers.
The detailed switching of each mode is as follows:
Idle one reporting cycle and
don’t trigger the heliometer,
Click once to activate, then press
After the report completed, the
current time is privacy time
Press for 6 seconds, still will turn
to Mode 5 after reset
To Next Page
Loading...