Simplex 4010ES Installation Instructions

Installing boards into 4010ES back boxes
This section describes mounting the 4010-9908 in 4010ES Back Boxes.
Installation the 4010-9908 card
The 4010-9908 4-Point AUX Relay Card (Figure 13) is designed to be mounted on the PDI card in a 4010ES panel. The card can be mounted on any of
the PDI blocks, provided it fits inside the available space. Use connector P1, labeled on the rear of the card, to connect to the PDI block.
Figure 13: 4010-9908 4-Point AUX Relay Card
See section 4100-3206 Wiring for information on the wiring of the 4010-9908 card.
page 15 579-220 Rev. F
4100/4120- Series and 4010ES Relay Modules Installation Instructions

Simplex 4010ES Specifications

General

Control Panel Type	Addressable Fire Alarm Control Panel
Display	LCD
Operating Temperature	32°F to 120°F (0°C to 49°C)
Power Supply	120V AC or 240V AC
Zones	10
Communication Ports	RS-232, Ethernet
Signaling Line Circuits (SLCs)	2
Notification Appliance Circuits (NACs)	4
Max Notification Appliances	Varies based on NAC configuration and power supply
Communication Options	Cellular, Ethernet
Weight	30 lbs
Humidity Range	Up to 93% non-condensing
Certifications	UL, FM, CSFM, MEA
Network Capability	Yes