Copyright and trademarks
Copyright (c) 2018 Johnson Controls. All rights reserved.
Information contained in this document is subject to copyright and shall not be reproduced in any form whatsoever, without the written consent of Johnson
Controls.
Information contained in this document is believed to be accurate and reliable. However, Johnson Controls reserves the right to change the content without prior
notice.
Tyco, Simplex, the Simplex logo, MAPNET II, IDNet, TrueAlarm, MINIPLEX, TrueAlert, MX are trademarks of Johnson Controls International or its affiliates in the
U.S. and/or other countries. VESDA is a trademark of Xtralis.
End user liability disclaimer
The wiring details described in this document are intended to allow compliance with the statutory requirements of Australian fire alarm systems. Some aspects of
compliance require corresponding settings in the configuration of the fire alarm system. Because this configuration will be customized by the User to define in
detail the operation of particular 4100ES or 4100ESi systems, changes may be made by the User that prevent this installation from meeting statutory
requirements.
Therefore, Johnson Controls cannot accept any responsibility as to the suitability of the functions generated by the User in any particular configured system.
Revision history
2.0 12-07-2016 Extensively revised for 4100ESi
2.1 17-11-2016
Added sheets 608 and 708.
Revised sheets 308, 309, 427, 603, 604, and 705.
Withdrew sheet 212.
2.2 23-01-2017 Revised sheet 207.
2.3 09-11-2017
Added sheets109, 429-432.
Revised sheets 600, 601, 606,609
2.4 31-10-2018
Added sheets 433, 434
Revised sheets 429-432, 707.
To Next Page
Loading...
Need help?
General
