Simplex 4100-9600 - User Manual

Communication and
Audio Interface Modules
Installation Instructions
© 2005-2011 SimplexGrinnell LP. All rights reserved.
Specifications and other information shown were current as of publication and are subject to change without notice.
Simplex and the Simplex logo are trademarks of Tyco International Ltd. and its affiliates and are used under license.
574-844
Rev. P
This publication describes the installation procedure for Transponder Interface Cards (TICs),
Audio Riser Modules, and the Network Audio Riser Controller Module for installation in 4100U
and 4100ES Fire Alarm Control Panels.
This product is compatible with 4100U and 4100ES Fire Alarm Control Panels (FACP).
This publication also includes connections that provide the Non-Alarm Audio (NAA) Interface
feature.
IMPORTANT: Verify FACP System Programmer, Executive, and Slave Software
compatibility when installing, or replacing system components. Refer to
the Technical Support Information and Downloads website for compatibility
information.
Topic See Page #
Cautions and Warnings 2
TICs and Audio Riser Modules 3
System Guidelines 8
Network Audio Riser Controller Module 9
Configuration 10
Mounting 12
Wiring 13
Digital Audio Riser Module (566-407,-833) 21
Non-Alarm Audio (NAA) Interface 23
Field Replacement of the Digital Audio Riser Module (566-243) 26
Digital Audio PDI Termination Plug 27
Introduction
In this Publication
firealarmresources.com

Simplex 4100-9600 Specifications

General

Model	4100-9600
Type	Fire Alarm Control Panel
Manufacturer	Simplex
Voltage	120/240 VAC
Frequency	50/60 Hz
Compatibility	Simplex devices and peripherals
Communication	RS-232
Communication Protocol	Simplex protocol
Display	LCD display
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	10% to 93% non-condensing

Summary

Cautions and Warnings

TICs and Audio Riser Modules

The Local Mode TIC

Local Mode

System Guidelines

RUI Guidelines

Provides critical wiring rules and specifications for RUI connections.

Configuration

Setting the Address

Explains how to set module addresses using DIP switches.

Mounting

Mounting Instructions

Details the procedure for mounting TIC and Network Audio Riser Controller Modules.

Wiring

TIC;Motherboard Interconnections

Illustrates how to connect TICs to a motherboard in another bay.

PDI Jumpers

RUI Wiring Configurations

Analog Interconnections

Connecting the 4100 U;4100 ES Analog Riser to Legacy 4100

Details connecting the analog riser to a legacy 4100 Audio Controller.

Amplifier and Harness Connections

Digital Interconnections (4100-1311 Digital Audio Controller)

Details digital wiring from the digital audio controller to risers.

Distributed Microphone Interconnections

Shows wiring for distributed microphone applications.

Multiple Digital Command Center Interconnections

Illustrates MCC network wiring for audio distribution.

Digital Audio Riser Module (566-407, -833)

DIP Switches

Explains DIP switch configurations for channel, density, and outputs.

Jumpers

Details jumper settings for analog audio input levels and supervision types.

Potentiometer R4

Non-Alarm Audio (NAA) Interface

NAA Wiring