12
TICs, Audio Riser Modules, and Network Audio Riser Controller Modules are 4” X 5” modules
and are mounted per the following information.
IMPORTANT: The TIC or Network Audio Riser Controller Module should be
mounted in the upper left position of the bay. The audio riser
module must be mounted directly below the TIC or Network Audio
Riser Controller Module.
1. Screw two standoffs and washers to the appropriate holes in the back of the cabinet.
These holes must line up with the screw holes in the 4 X 5 card. See Figure 4.
2. Plug the 4” X 5” card into the top left PDI connector (P8).
3. Secure the top of the card to the standoffs with two #6 torx screws and washers.
Note: Figure 4 is a general-purpose illustration that applies to most
4” X 5” cards.
Figure 4. TIC or Network Audio Riser Controller Module Mounting
Mounting
Mounting
Instructions
TIC OR
NETWORK
AUDIO RISER
CONTROLLER
MODULE
STANDOFFS
#6 SCREWS
WASHERS
PDI CONNECTOR
(reverse side)
PDI
SCREW
RETAINERS
To Next Page
Loading...
