EasyManua.ls Logo

Simplex Flex 4100U User Manual

Simplex Flex 4100U
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Flex Amplifiers
Installation Instructions
© 2003, 2009, 2011 SimplexGrinnell LP. All rights reserved
Specifications and other information shown were current as of publication and are subject to change without notice.
Simplex and the Simplex logo are trademarks of Tyco International Ltd. and its affiliates and are used under license.
579-173
Rev. H
This publication describes the installation procedure for the 4100U and 4100ES Flex Amplifiers.
This product is compatible with both 4100U and 4100ES Fire Alarm Control Panels (FACP).
IMPORTANT: Verify FACP System Programmer, Executive, and Slave Software
compatibility when installing, or replacing system components. Refer to
the Technical Support Information and Downloads website for
compatibility information.
This publication discusses the following topics:
Topic See Page
Cautions, Warnings, and Regulatory Information 2
Introduction to the Flex Amplifiers 3
Amplifier Specifications 5
Setting the Baud Rate and Address 6
Installing the Amplifier onto the PDI 8
Amplifier Field Wiring 11
LED Indications 15
Troubleshooting 16
Introduction
In this Publication
firealarmresources.com
Question and Answer IconNeed help?

Do you have a question about the Simplex Flex 4100U and is the answer not in the manual?

Simplex Flex 4100U Specifications

General IconGeneral
BrandSimplex
ModelFlex 4100U
CategoryAmplifier
LanguageEnglish

Summary

Introduction

Cautions, Warnings, and Regulatory Information

Introduction to the Flex Amplifiers

Overview

Describes the Flex amplifier's function and versions, including compatibility notes.

Amplifier Specifications

Setting the Baud Rate and Address

Overview

Explains how to configure amplifier baud rate and address using DIP switch SW1.

Using DIP Switch SW1

Details the function of DIP switches SW1-1 through SW1-8 for configuration.

Installing the Amplifier onto the PDI

Overview

Describes mounting placement of Flex amplifiers on the Power Distribution Interface (PDI).

Mounting

Details the physical process of lowering and connecting the amplifier to the PDI bay.

Amplifier Field Wiring

Overview

Provides an overview of field wiring guidelines for Flex amplifiers.

Class B Wiring

Details field wiring guidelines for Class B speaker circuits.

Class A Wiring

Details field wiring guidelines for Class A speaker circuits.

Constant Supervision NAC (CSNAC) Wiring

Explains wiring for Constant Supervision NAC (CSNAC) modules.

LED Indications

Flex Amplifiers Not Compatible with CSNAC Option

Summarizes LED indications for Flex amplifiers not compatible with the CSNAC option.

Flex Amplifiers Compatible with CSNAC Option

Summarizes LED indications for Flex amplifiers compatible with the CSNAC option.

Troubleshooting