Simplicity 1613H - Mowing Pattern & Tips; Pushing Tractor by Hand

Operation
MOWING PATTERN & TIPS
For the first use of the mower choose a smooth level area.
Cut long straight strips overlapping slightly.
The size and type of area to be mowed determines the best
mowing pattern to use. Obstructions such as trees, fences
and buildings must also be considered. Where possible,
make one or two passes in a clockwise direction around the
outside of the area to keep cut grass off fences and walks.
The remainder of the mowing should be done in a
counterclockwise direction so the clippings are dispersed on
the cut area.
Most lawns should be mowed to keep the grass
approximately two to three inches (50 to 76 mm) high. Best
results are obtained by cutting often and not too short. To
help keep a green lawn, never mow more than one third of the
height of the grass, or a maximum of one inch (25 mm), in
one mowing. For extremely tall grass, set the cutting height
at maximum for the first pass, and then reset to the desired
height and mow again.
Adjust the cutting height as necessary. For best appearance,
grass should be cut in the afternoon or early evening (in
daylight) when it is free of external moisture.
Where possible, change patterns occasionally to eliminate
matting, graining or a corrugated appearance.
PUSHING TRACTOR BY HAND
To push the tractor by hand, the transmission release lever
(A, figure 7) must be engaged (toward the rear of tractor).
To drive tractor, the release lever must be placed back in the
“drive” position (towards front of tractor). Refer to figure 7.
16