9
CONTROLS
(Fig 9)
The suction power can be regulated
by using the Digital Power Control to
achieve optimal cleaning results. To
change the suction power to suit a
particular cleaning task, press the Power
Increase Button to increase the suction
power, and to reduce the suction power,
press the Power Decrease Button.
The Dust Bag Indicator will continually
flash red to indicate that the dust bag
requires replacement or to indicate that
there is a blockage. (Fig 9)
• Low Power Suction (Hard Floor and
upholstery)
• Medium Power Suction (Hard Floor and
upholstery)
• High Power Suction (Hard Floor and
upholstery)
• Low Power Suction (Lampshades/Drapes)
• Medium Power Suction (Lampshades/
Drapes)
• High Power Suction (Lampshades/Drapes)
• Power Decrease Button
• Power Increase Button
Note: In the two lowest settings, the dust
bag indicator will not flash.
Tip: If the powerhead is too difficult to
push on the carpet, reduce the suction
by pressing the power decrease button
or the control panel on the handle
To Next Page
Loading...
Need help?
General
