16- ENG
4. Turn the machine OFF and squeeze the trigger to re lease the trapped pressure
inside of the machine.
5. Remove both the garden hose and high pressure hose from the unit.
6. Disconnect the wand from the gun.
7. Turn ON the machine and allow it to
15
run for 5 seconds. (This will clear
out most of the water trapped in the
pump).
8. Unplug machine .
9. Wrap high pressure hose and power
supply cord onto storage rack and
snap power supply cord into place
as shown.
10. Store the machine and accessories
in a dry, climate controlled
environment. Do not store the
machine or accessories in a place
where the temperature could drop
below 40°F (4°C).
ACCESSORIES
DANGER: Risk of fluid injection. When using replacement wands or guns
with this pressure washer, DO NOT use a wand and/or wand/gun combi-
nation that is shorter in length than what was provided with this pressure
washer as measured from the nozzle end of the wand to the gun trigger.
NOTICE: The use of any other accessory not recommended for use with this
tool could be hazardous. Use only accessories rated equal to or greater than
the rating of the pressure washer.
SpECIFICATIONS
Model 13SIE-170
Rated Pressure* 1700 psi
Rated Water Flow* 1.3 gpm
Electrical Requirements 120V,
13 A, 60 Hz
Electrical Cord 35 ft. (10.67m)
High Pressure Hose 23 ft. (7.0 m)
Minimum Amp Source 15 A
Presure of Inlet Water 20–100 psi
Inlet Water cold tap
Soap Consumption Rate 10% max
* Rated Pressure and Rated Water Flow is within manufacturing tolerance of
(+/- 10%).
In a continued commitment to improve quality, the manufacturer reserves the right
to make component changes, design changes, or specification changes when
necessary and without notice.
To Next Page
Loading...
