6. INSULATION RESISTANCE MEASUREMENT
Be certain that the device under test (DUT) is voltage-free before preforming
measurements; see paragraph 5. If voltage is present see paragraph 6.05.
For measurements over 10 G 1, the guard cable (cat. No 45065) is
recommended; see paragraph 6.3.
6.05 DISCHARGING THE DEVICE UNDER TEST
The function selector switch must be switched from 1back to V, in order to
discharge test voltage from DUT. The range selector switch can be left at the
original setting.
9
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
