S1 (D,E) State of relay when not in alarm: De-energized,
Energized.
S2 (D,E)
S3 (D,E)
S4 (D,E)
AOH (NUM) Set the Analog Output Hi Limit
AOL (NUM) Set the Analog Output Lo Limit
FS (0, 1, 2) Analog Output Fail Safe Mode
ffO = O
leveL oL = 1
leveL iH = 2
PAS (NUM) Change Password to the following NUMber. (000
through 999 and -999)
Note: Linearization points must be loaded in ascending order, or unit will function
erratically.
LP0 Linearization Off (Display values as measured
electrically).
LP(1 – 16) The number of linearization points to be load-
ed.
L1 (eVALUE),(dVALUE) One point Linearization. Refer to the table on
Linearization (6.5.6 and 6.5.7)
L2(eVALUE),(dVALUE) Two point Linearization.
L3 (eVALUE),(dVALUE)
L4 (eVALUE),(dVALUE)
L5 (eVALUE),(dVALUE)
L6 (eVALUE),(dVALUE)
L7 (eVALUE),(dVALUE)
L8 (eVALUE),(dVALUE)
L9 (eVALUE),(dVALUE)
L10 (eVALUE),(dVALUE)
L11 (eVALUE),(dVALUE)
L12 (eVALUE),(dVALUE)
L13 (eVALUE),(dVALUE)
L14 (eVALUE),(dVALUE)
L15 (eVALUE),(dVALUE)
L16 (eVALUE),(dVALUE) Sixteen point Linearization.
EXIT Implement previously sent commands. The Hawk
3 will then resume monitoring its input and operat-
ing relays.
Note: EXIT does not permanently save the changes.
SAVE
Save present settings in flash memory.
Note: This step allows the unit to remember changes after a power down and to
allow the Hawk 3 to resume normal operations. This step is not required for com-
31
To Next Page
Loading...
Need help?
General
