Simpson MS60920 - Quick Start Guide (Continuing); Connect Spray Wand to Spray Gun; Connect Quick Connect Nozzles; Ensure Water Faucet is Fully Open

9 - ENG
4
Connect Spray
Wand to Spray
Gun
Thread the spray
wand into the end
of the spraygun.
5
Connect QC
Nozzles to Spray
Wand
Pull quick connect
coupler back and insert
nozzle. Release quick
connect coupler and
twist nozzle to make sure
it is secure incoupler.
6
Turn Water
Faucet
Completely On
Do not run the unit
without water supply
connected and turned on.
Use Cold WaterOnly.
7
Release Air from
System
Release all
air from pump and
high pressure hose by
depressing trigger until a
steady stream of water is
present. Approximately
30seconds.
8
Verify the Engine
Switch is turned
to the ON
Position
OFF
ON
9
Verify the Choke
Pin is Pulled Out
to the CLOSED
Position
The Choke Pin has been
preset by the factory to be
in the CLOSED Position.
10
Pull the Recoil
Starter Grip
Pull the recoil starter
grip to start the engine.
11
Push the Choke
Pin to the
OPEN
Position
Gradually move the
Choke Pin to the
OPEN Position after
engine starts.
WARNING: This Guide is not a substitute for reading the operator's manual.
User must read and understand operator's manual before using thisproduct.