9
OPERATING INSTRUCTIONS
NOTE: The pump on this unit is maintenance free and requires no oil. If there is a problem with the
pump, contact our Customer Service Group on www.power-washer.us as soon as possible.
Risk of bursting. Use a tire pressure gauge to check the tire pressure before each use
and while inating tires; see the tire sidewall for the correct tire pressure.
NOTE: Air tanks, compressors, and similar equipment used to inate tires can ll small tires similar to
these very rapidly. Adjust pressure regulator on air supply to no more than the rating of the tire pres-
sure. Add air in small increments and frequently use the tire gauge to prevent over ination.
The engine is shipped without oil. Before starting engine, add the oil provided. Damage
to the engine will occur if the engine is ran without oil, this damage will not be covered under
warranty.
Compare the illustrations with your unit to familiarize yourself with the location of various controls
and adjustments. Save this manual for future reference.
BASIC ELEMENTS OF A PRESSURE WASHER
High Pressure Pump: Increases the pressure of the water supply.
Engine: Drives the high pressure pump. Refer to the engine manual for location and operation of
engine controls
High Pressure Hose: Carries the pressurized water from the pump to the gun and spray wand.
Spray Gun: Connects the spray wand to control water ow rate, direction, and pressure.
High Pressure Pump
Engine
Spray Gun
High Pressure Hose
Quick Connect Spray Wand
To Next Page
Loading...
