SimPure Q3-600 - Assembling System Components; Releasing Tube from Quick-Connect; Inserting Tube into Quick-Connect

Step 5 - System Flushing(start up the system and filter replacement)
1.System flushing---Turn on the Feedwater valve and gooseneck faucet, then
plug in and let the system run for 20 minutes to rinse all fittings and the new
filters. Check if any signs of leaks.
Warning: Make sure the socket under the sink is powered on, and ensure the
system has been plugged correctly into the power outlet.
2.Enjoy your drinking water---After flushing, the system is ready for use.
Turn on the faucet and enjoy it.
Note: There will be some noise when the system is running, this is normal.
The noise will disappear when the faucet is turned off.
Uncertain about something? Is there a problem?
Please contact SimPure® through our website or toll-free number.
Customer Service: service@simpurelife.com
Toll-Free :1-866-528-4572
Website: www.simpurelife.com
CONGRATULATIONS!
You have completed the installation!
15
Assemble the Components
The SimPure® Q3-600 Water Purification system uses quick-connect (QC)
fittings making the installation simple and easy.
e How to release tube (or plug) from a quick-connect.
. t t
- . Pull Pull
Hold
I'4
‘¢’ clip
Remove lock clip
position
(1) Remove the locking C-clip by sliding it out from under the quick- connect
fitting collet.
(2) Push the collet down onto the fitting (closing the gap between the collet
and fitting) and hold.
(3) While holding the collet down, gently pull tube (or plug) in the opposite
direction at the same time to release.
e How to insert tube into a quick-connect.
- 1/4” tube: 3/5"(15mm) e B
3/8" tube: 3/4"(19mm)
-y ‘ Push
’ ‘C’ clip
Locked into position
(1) Make sure the tube has a clean square cut with no bur present.
(2) Push the tube firmly into the QC fitting, making sure it is located correctly
(you will feel the tube 'jump' into position as you push it into the fitting).
The 1/4" tube is secure once it has traveled */s" (15mm) into the fitting.
The 3/8" tube is secure once it has traveled /4" (19mm) into the fitting.
(3) Replace the locking C-clips to secure the QC fitting.
16