SimPure V7 - Operation and Maintenance Guide

Operation and Maintenance Guide
The System is designed to filter feed water whenever the faucet is operated.
Filter cartridge replacement
Replacement Filter Part Number
HEUSX002_S9 V7 Filter Cartridge 12months
Note: Depending on your feed water quality, the V7 Filter Cartridge can last up
to 12 months; however, if you use a lot of water or have poor feed water quality,
you may need to replace your Filter Cartridge sooner.
o D
t 14
- & B g op
A B [«
Step 1 - Close the shut- off valve and open the faucet to release any water
pressure.
Step 2 - Unscrew the housing and pull out the old filter cartridge.(See Figure A)
Step 3 - Insert the new filter cartridge and run it in till you hit the ultimate
stop,then tighten the housing.(See Figure B)
Note:Before installing a new filter cartridge, be sure to remove impurities and
rinse with water to ensure the seal and seal area are clean.
Step 4 - Run water to drain for 5 mins to rinse the new cartridge.
Note: You may notice Black Carbon particles for the first minute, this is normal.
Note: If you find it difficult to unscrew and tighten the housing, you can
use the spare wrench tools. (See Figure C)
13
Frequently Asked Questions
Q: Why doesn't the TDS value lower after filtration?
A: The main purpose of this SimPure V7 filter is not to remove TDS. TDS stands
for total dissolved solids, and it is basically composed of inorganic salts and a
small amount of organic matter. The filter can remove harmful substances while
keeping beneficial trace elements. Please choose SimPure RO system if you are
looking for physical removal of TDS.
Q: When should I replace the cartridge?
A: The filter's service life is related to the water quality. If the flow rate is
significantly reduced or if the water has a peculiar smell, we suggest that you
replace the cartridge.
Q: Why does black water come out during flushing?
A: It’s normal that black water comes out when flushing. The purpose is to
remove carbon powder remaining on the surface of filter materials. You can
normally use it after flushing for 5 minutes.
Q: What should I do if the filter is leaking?
A: Turn off shut off valve first.
1. If the QC fitting is leaking, remove the tube, clean and re-insert.
2. If threaded fitting, tighten or re-tape with Teflon Tape.
3. If between the housing and base, clean the dirt inside the base, make sure the
gasket is clean, and tighten it.
Q: What should I do if there is no water from the faucet?
A: Make sure the shut off valve is open, and there is water available. If using
Teflon Tape make sure it has not blocked the water supply (re-tape fittings if
necessary)
Customer Service: service@simpurelife.com
Toll-Free :1-866-528-4572
Website: www.simpurelife.com
14