Feed Water Tank Cleaning
To maintain your System, it's recommended to clean the Feed Water Tank and
components after every three months of use; this helps to extend the service life
of the filter elements. Check the Feed Water Tank strainer, diversion sleeve, and
two check valves located on the bottom of the Tank are clean.
Tank Strainer and Sleeve Cleaning instructions
Remove the Feed Water Tank and empty the water, located in the bottom of the
Tank you will see the strainer and diversion sleeve, pull them both out. Clean
the parts with a brush under running water. Once clean, refit them. Next clean
the check valves. Refill the Feed Tank with clean water and place back into the
System base, making sure to locate it correctly.
Top Tip:
When it's time to refill the Feed Water Tank, why not give your plants the
leftover tank concentrate water instead of pouring it down the sink!
Customer Service: service@simpurelife.com
Toll-Free:1-866-528-4572
Website: www.simpurelife.com
Plug the System into the electrical outlet and
make sure the outlet switch is on (if applicable)
You will hear 2-beeps when connecting to the
power.
If the System does not turn on after following
the instructions above, please contact SimPure
®
customer service for assistance.
To Next Page
Loading...
