SimPure Y7P-W - Page 7

Control and Display Panel
RO Fitering Uv Ghange FueWatr
Flushing 180ml 350ml 450mI Reset
CF /RO
Indicates when the user needs to replace the filters.
Filtering
Indicates System is filtering water.
UV (UV wavelength range: 260~280nm, UV dose: 35p]/cm?)
Indicates that the Ultraviolet light is working.
Change Water
Indicates the Feed Water Tank contents must be emptied and refilled.
Pure Water Shortage
Indicates that there is not enough pure water in the interal pure water
reservoir, need to wait for the system to filter
Flushing
Indicates the System is flushing.
180ml / 350ml / 450ml Dispense
Indicates the System will dispense the selected amount of purified water.
Reset
Indicates when the filter cartridges are exhausted
Please refer to page 12 for full detailed descriptions of each function.
Connecting up the System
Unpacking- Choose a suitable countertop,
flat, secure, and out of easy reach of small
children. Place the drip tray under the outlet.
Allow rear space for access. Open the feed
water tank cover and lift out the water tank.
The System is already pre-fitted with the filter
cartridges for your convenience.
Fill water tank- Fill with potable (tap) water,
then carefully fit the Feed Water Tank into the
base of the System, making sure the tank lid is
installed correctly, or the System will not
operate. When refilling the Tank, always
EMPTY the remaining water before refilling.
DO NOT exceed the MAX level.
Step 3
Turn the System on- Pluginto an electrical
outlet. All indicator lights will be on and flash
@ twice. You will hear 2-beeps. Flushing, 180ml,
- 350ml, 450ml, and Reset indicators will all be
@ lit for a short period when the system is turned
on.
IMPORTANT:
TO ENSURE GREAT TASTING FRESH WATER AND TO EXTEND
THE FILTER CARTRIDGE LIFE ITS RECOMMENDED TO EMPTY
AND REFILL THE FEED TANK WATER ON A REGULAR BASIS
(ONCE A DAY).
Notes:
There is no power switch; unplug device should you need to turn it off.