SimPure Y7P-W - Page 8

Flushing System
If you are commissioning the system for the first time or have just
replaced the filter cartridges, please follow the below steps for 3-5
TIMES to ensure that the system gets adequately flushed before using.
Step 01
Always start the system flushing with a new
tank of the potable (tap) water. Carefully fit
the feed water tank back into the tank base
and close the cover.
oo
Step 02
Place a large container on the drip tray
and have another container ready to
alternate.
Step 03
Plug it in, the system will automatically flush the
@ membrane for 30 seconds, then the "filtering”
o indicator light will be on.
@ (Membrane flushing is the internal flushing.
The flushed water will be returned to the feed
water tank with no water out of the water spout.)
Filtering - the system will automatically start
to filter and transfer the pure water to the
internal pure water reservoir. Waiting until
the filtering indicator light turns off (about
10 mins), which means that the internal
pure water reservoir is full.
Step 05
Push 1s Empty the internal pure water reservoir
to flush - Push the "Flushing" button: the
pure water will start to flow from the outlet
until the internal reservoir is empty.
The system will continue to filter when the
internal pure water reservoir is empty.
Waiting until the "filtering" indicator light
turns off again and pushing the "Flushing"
button again to empty the internal pure
water reservoir.
Push 15
Continue repeating the steps 4-6 until
the "Change Water" indicator light starts
‘m flashing, empting the remaining water
in the Feed Water Tank.
Step 08
The above steps 1-7 are the one round of system
flushing process. Please repeat these steps for 3-5
TIMES to complete the system flushing.
Note:
1. Every water supply is different. Depending on your feed
water sourceand quality, you can adjust the flushing frequency.
2. New system may have air bubbles, particulates or slightly
poor taste, this is normal, please follow these flush instructions
to remedy the situation.
10