IS15 Wind Manual
36 20220752G
Notes !
1. The Roblink must be turned Off when the instrument is used as a
single NMEA repeater. However, if more heads are daisy-chained
as NMEA repeaters the Roblink must be On.
2. When the Roblink has been turned Off it will not default to ON
even after a Master Reset. If required it must therefore be turned
On again using the procedure above.
Screen 9
ROBLINK TEST [tESt]
Refer to section 7 ‘Fault Finding’ for details.
Screen 10
COMMUNICATION RESET [C.rES]
Allows you to reset the system communication (Roblink) in the
event anomalies are observed on one or more instruments. This
reset will not default the calibration or settings.
Press the button and hold for 2 seconds. The LCD display
shows ‘P.OFF’. Turn the system off, refer to the beginning of
this section and assign the instrument(s) to the system.
Screen 11
MASTER RESET [rES]
When a MASTER RESET is performed on one of the
instruments in a system it becomes system wide and all
instruments are reset to default values.
Note ! Do not perform a Master Reset unintentionally because it will default
settings and calibration values.
Press the button and hold for 2 seconds. The LCD display
shows ‘P.OFF’. Turn the system off, refer to the beginning of
this section and assign the instrument(s) to the system.
Note ! After the Master Reset a new set-up has to be performed.
To Next Page
Loading...
