IS15 Wind Manual
22 20220752G
7. Lock the retaining clip into place (3).
Note !
Remove the wand in the reverse order.
8. The cable is easily threaded down the mast if a pull-through
cord or mouse has been left for that purpose. If there is no
mouse, it may help to fix a weight to the end of the cable to
assist its passage through the mast.
9. If there is a small error in the alignment of the masthead
unit, this can be compensated for. Please refer to the
relevant calibration instructions for more details.
Note ! The masthead bracket includes an integral weatherproof cap that should
always be fitted to the socket if the wand has been removed.
5.4 Cabling
Stand Alone system (W-1)
Wind
Transducer
IS15 Wind
SIMRA D
Junction box (mast foot)
Supply 10,8-15,6VDC
10m (33')
30m (99')
Speed/heading
input on NMEA
Circuit breaker
*
**
Roblink cable with connector
(Special) Roblink Power Cable
*
**
Fuse 2A
Figure 5-3 W-1 IS15 Wind System
Use the Roblink Power Cable (P/N 22093587) for supply to
connector no. 1. Cut off one of the plugs on the supplied 0,3 m
(1’) cable and extend it to the NMEA source using twisted pair
cable. Use connector no. 4 for NMEA connection (see Figure
5-9). Connect the Wind Transducer to no. 3 connector (sensor).
To Next Page
Loading...
