IS15 Wind Manual
12 20220752G
6. Press the button, hold for 2 seconds and release to save
the limit setting.
7. Press the button and hold for 2 seconds to return to the
main screen.
2.5 Alarm Sounding
Alarms are system wide and all the instruments will sound and
flash a warning message.
If there is an external alarm connected this will sound at the
same time (only if an IS15 Expander is part of the system).
To cancel a sounding alarm press any button on any of the
instrument heads.
Note ! The flashing warning will remain as long as the alarm condition exists
and disappears automatically when there is no longer an alarm
condition. The sounding alarm will always have to be cancelled.
Alarm messages
The symbols that are shown when an alarm is triggered are as
below:
‘SHAL’ = The Shallow Water Alarm
‘dEEP’ = The Deep Water Alarm
‘AnCH’ = The Anchor Alarm
‘HIGH’ = The High Wind Speed Alarm
‘Er.XX’ = System failure (Contact your Simrad dealer).
To Next Page
Loading...
Need help?
General
