When this has been achieved fully tighten the rear module screws and
then the heatsink screws at the front.
Solder the tinned copper wire from the Antenna socket into the board,
then fold down the 2 tags, from the Antenna socket copper washer, onto
the PCB and solder both tags down to the pads.
3.2 RD68 Final Assembly
Fit the Cover Seal E03117 into the top cover ensuring that the seal lays
into the recess around the cover. Refer to drawing E03847, place
Screen / Insulator Assembly E03223 on top of the PCB in the Chassis
Assembly E03848 with the Leatheriod insulator down towards the board.
Fit Top Cover onto Chassis assembly and fix down using 5 off M3 x 16
Pan Head Slot Screws fitted with M3 Nyltite Sealing Washers 200252,
fully tighten ensuring that the seal remains correctly fitted. Refer to
drawing E03849 and fit the Front Panel Seal E03116 to the Front Panel
Assembly E03850 as shown, ensuring that the 6 small 'feet' attached to
the seal sit down onto the PCB. Take the four sets of wires from PLUGS
1 – 4 on the front panel and, referring to the drawing below, plug them
into their correct connectors as shown.
To Next Page
Loading...
