Simrad RI35 Mk2 - Connection to J101 A;J200 S Junction Units

Simrad RI35 Mk2 Rudder Angle Indicator
10 20220919D
* Non polarized (colour independant)
J45S JUNCTION UNIT
RF45X
RUDDER FEEDBACK
UNIT
12 11 10
GND RUDDER FB I/P
+OUT
BLUE GREEN
RED
*
FREQ SUPPLYCURR
RI35 Mk2
RUDDER ANGLE
INDICATOR
SUPPLY VOLTAGE 12/24V
RI35 Mk2
RUDDER ANGLE
INDICATOR
FREQ SUPPLY
CURR
*
Use a separate
terminal for this
connection
NMEA NMEA
Figure 3-8 RI35 Mk2 - J45S Wiring diagram
Note ! Autopilot supply and Indicator supply must have common GND.
Connection to J101A/J200S Junction Units
J101A/J200S JUNCTION UNIT
RF100
RUDDER FEEDBACK UNIT
RI35 Mk2
RUDDER ANGLE
INDICATOR
SUPPLY VOLTAGE 12-24V DC
*
12 11 10
GND RUDDER FB I/P
+OUT
BLUE
GREEN
RED
11
FREQ SUPPLYCURR
GREEN
* Non polarized (colour independant)
Use a separate terminal
for this connection
NMEA
RI35 Mk2
RUDDER ANGLE
INDICATOR
*
FREQ SUPPLYCURRNMEA
11
Move this connection to
the next instrument if two
are installed
Figure 3-9 RI35 Mk2 - J101A/J200S Wiring diagram
If more than two indicators are needed, use the NMEA port as per
Figure 3-10.
Note ! Autopilot supply and Indicator supply must have common GND.