Simrad RI35 Mk2 Rudder Angle Indicator
12 20220919D
3.4 Bracket mounting
• Mount two of the bracket halves to the RI35 Mk2.
• Temporarily bolt together the other two halves of the bracket to the
first two halves.
• Hold the RI35 Mk2 in place by hand and mark the 4 holes for the
fixing screws on the mounting surface.
• Remove the RI35 Mk2, drill the 4 mounting holes in the mounting
surface.
• Unbolt the temporarily fitted bracket halves and secure them to the
mounting surface using the self-tapping screws.
• Assemble the complete bracket again and adjust the RI35 Mk2 to
best viewing angle and tighten up the mounting bracket bolts.
Figure 3-12 RI35 Mk2 Bracket mounting
3.5 Illumination
Internal LED’s illuminates the scale. The illumination is turned on and
adjusted in three steps by the front panel keypad.
To Next Page
Loading...