12
Technical Information
6. Function and Control
6.1 Remote Controller Introduction
Introduction for icons on display screen
Introduction for buttons on remote controller
Note:
● This is a general use remote controller. It could be used for the
air conditioner with multifunction. For the functions which the model
doesn't have, if press the corresponding button on the remote
controller, the unit will keep the original running status.
● After putting through power, air conditioner will give out a sound
and operation indicator " " is ON (red indicator,the colout is
different for different models). You can operate the air conditioner
through the remote controller.
●
Under on status, pressing the button on the remote controller, the
signal icon " "on the display of remote controller will blink once
and the air condition-er will give out a sound, which means the signal
has been sent to the air conditioner.
button
Press this button to turn on the unit. Press this button again to turn
o the unit.
button
Press this button to select your required operation mode.
●When selecting auto mode, air conditioner will operate
automatically according to ambient tem-perature. Set temperature
can't be adjusted and will not be displayed as well. Press "FAN"
button can adjust fan speed.
●When selecting cool mode, air conditioner will operate under cool
mode. Press "+" or "-" button to adjust set temperature. Press "FAN"
button to adjust fan speed.
●When selecting dry mode, the air conditioner operates at low
speed under dry mode. Under dry mode, fan speed can't be
adjusted.
●When selecting fan mode, the air conditioner will only blow fan, no
cooling and no heating. Press "FAN" button to adjust fan speed.
●When selecting heat mode, the air conditioner operates under heat
mode. Press "+" or "-" button to adjust set temperature. Press "FAN"
button to adjust fan speed.
*NOTE
：
For preventing cold air, after starting up heat mode, indoor unit
will delay 1~5 minutes to blow air (Actual delay time depends on
indoor ambient temperature). Set temperature range from remote
controller: 16~30
o
C(61-86
o
F).
This mode indicator is not available for some models. Cooling
only unit won't receive heat mode signal. If setting heat mode with
remote controller, press " " button can't start up the unit.
button
This button is used for setting Fan Speed in the sequence that goes
from AUTO, , , to , then back to Auto.
*NOTE
：
Fan Speed " " is not available for some models, Fan Speed
" " is the same with Fan Speed " " for some models.
Under AUTO speed, air conditioner will select proper fan speed
automatically according to factory default setting.
AUTO speed is only available for some models.
It's low fan speed under dry mode.
X-FAN function: Holding fan speed button for 2s in cool or dry mode,
the icon " " is displayed and the indoor fan will continue operation
LED
Set temperature
WiFi function
Sleep mode
Light
Clock
X-FAN function
Indoor ambient temp.
Set time
TIMER ON / TIMER OFF
Up & down swing
Child lock
Operation mode
Send signal
Auto mode
Cool mode
Dry mode
Fan mode
Heat mode
Set fan speed
To Next Page
Loading...
