16
2.11 Select a Cartridge
-
It is enabled only for the 2X/2X DP303, 5X and 7X. When two models or a model consisting of two or more
meshes is loaded, it may print with a different cartridge by specifying the cartridge number for each mesh or object.
-
Press the button to check the filament amount of each cartridge.
1 When the Layer Color is off, [Select a Cartridge]
To print Mesh 1 with Cartridge 1 and Mesh 2 with Cartridge 2, select the cartridge for each Mesh as shown
above.
2 When the Layer Color is on, [Select a Cartridge]
If the Layer Color is activated, a 3D model cannot be right-clicked. (To delete or move object.)
For DP200/DP102, DP201/DP202/DP203, 3DWOX 1/DP103 and 1X/1X DP302
-
Pause the printing on the desired layer. Unload the cartridge, replace it, and continue printing.
To Next Page
Loading...
