Sinee A90 Series User Manual

User Manual of A90 Series Inverter
75
4: output frequency detection
FDT2
5: reverse running (REV)
6: jog
7: inverter fault
8: inverter ready to run (READY)
9: reach the upper frequency limit
10: reach the lower frequency
limit
11: valid current limit
12: valid overvoltage stall
13: complete simple PLC cycle
14: reach the set count value
15: reach the specified count
value
16: reach the length
17: motor overload pre-alarm
18: inverter overheat pre-alarm
19: reach the upper limit of PID
feedback
20: reach the lower limit of PID
feedback
21: analog level detection ADT1
22: analog level detection ADT2
23: retention
24: undervoltage state
25: motor overheat pre-alarm
26: up to the set time
27: zero-speed running
28-37: retention
38: off-load
39-46: retention
47: PLC output
48-58: retention
59: sleep indicator
69: FDT1 lower limit (pulse)
70: FDT2 lower limit (pulse)
71: FDT1 lower limit (pulse,
invalid in JOG)
72: FDT2 lower limit (pulse,
invalid in JOG)
F03.05
Options of output
signal type
D7
D6
D5
D4
D3
D2
D1
D
0
*0000
○
*
*
*
*
*
R1
*
Y

Sinee A90 Series Specifications

General

Brand	Sinee
Model	A90 Series
Category	Inverter
Language	English