THREADING THE BOBBIN CASE
1. Open slide plate. Hold bobbin so that
thread unwinds in direction shown, and
put bobbin in bobbin case.
2. Pull thread into notch, draw it under
tension spring and back into slot.
3. Draw about three inches of thread
diagonally across the bobbin.
4. Ciose slide plate allowing thread to
enter slot between the needle plate and
the slide plate.
Instrukcje obsługi maszyn do szycia firm Polskich jak i zagranicznych np. Singer Toyota Pfaff Gritzner Łucznik Arka
maszynykrawieckie.shophurt.pl
To Next Page
Loading...
