Singer 968 - Adjusting Bobbin Winder; Adjusting Motor Belt Tension

Adjusting Bobbin Winder
4f there is too much threed on the bobbin:
• Loosen stop latch screw A.
e Slide latch B to the left for less tfread on
bobbin.
e Tighten stop latch screw.
If there is not enough thread on the bobbin:
e Loosen stop latch screw A.
e Slide latch B to the right for more thread on
bobbin.
e Tighten stop latch screw.
Adjusting Motor Belt
Tension
Tension on the motor belt should be Just
sufficient to keep the belt from siippingl if the
motor belt needs adjustment:
e Loosen motor bracket screw C a full turn,
e To increase belt tension, lower the motor
bracket.
• To decrease belt tension, raise the motor
bracket.
e Tighten motor bracket sarew C.
63