SAFETY
TB18 Plus&20J Plus Operation Manual 3-7 © Apr 2022
UNSAFE OPERATION HAZARDS
• Do not use the machine as a
crane.
• Do not use the platform to push
the machine or other objects.
• Do not allow the platform or
boom to touch nearby
structures.
• Do not use rope or other
binding materials to tie the
platform or boom onto nearby
structures.
• Do not place loads outside the
platform.
• When the platform is caught or
stuck or when other objects in
the vicinity impede its normal
movement, do not use the
platform controller to lower the
platform. If you intend to lower
the platform with a ground
controller, you must operate it
only after all personnel have
left the platform.
• When one or more of the
machine’s tires are off the
ground, evacuate all personnel
before attempting to stabilize
the equipment. Use a crane,
forklift or other suitable
equipment to stabilize the
machine.
FALL HAZARDS
At a minimum, operators must operate and maintain the
machine as stated in the operation manual and in the
maintenance manual in addition to following more
stringent industry regulations and workplace rules.
FALL HAZARDS
• Each person on the platform must
wear harnesses or use safety
equipment consistent with
government regulations. Fasten
the cable to the fixed point of the
platform. Never fasten the cable of
more than one person to a fixed
point on the platform.
• Do not sit, stand or crawl on the
guardrails. When on the platform
always remain standing on the
platform floor.
• Do not enter or exit the platform
through the boom.
• Keep the platform floor free of
obstacles.
• Do not allow mud, oil stains,
grease or other slippery
substances reside on the
footwear or platform floor.
• Do not enter or exit the platform
unless the machine is fully in
stowed position.
• Close the platform entrance door
before operating the machine.
• Do not operate the machine if the
handrails are not properly
installed and the platform entry
door is not closed.
COLLISION HAZARDS
At a minimum, operators must operate and maintain the
machine as stated in this manual and in the
Maintenance Manual in addition to following more
stringent industry regulations and workplace rules.
To Next Page
Loading...
