SINTERIT Lisa X - Printer Safety During Repair and Maintenance; Powder Safety While Working

Sinterit LISA X User Manual | 8
3. Removing and cleaning the printout
1. When it becomes possible to remove the printout, the REMOVE PRINTOUT button will be displayed. Press REMOVE
PRINTOUT.
2. The screen may display a message about the maintenace time of the components. For more information consult the
full instruction manual, and our website: www.sinterit.com/support/. Press GOT IT. If the message hasn’t appeared,
it means that at present no components require any maintenance.
3. Press the UNLOCK LID button to release the electrolock and allow the print chamber to be opened
IMPORTANT!
After 10 seconds the lock will re-engage and it will no longer be possible to lift the lid. If you still
want to open the printer lid, press the UNLOCK LID button again on the screen.
4. Push on the lid and pull it up using the handle (g. 3.1).
Fig. 3.1 Lifting the printer lid.
5. Make sure no miscellaneous items remain in the print chamber and press POSITION BEDS.
6. Place the folded IO BOX inside the print chamber. Make sure its elements are arranged like in the picture (g. 3.2.)
FEED BED PRINT BED
Fig. 3.2 The proper arrangement of the IO BOX, allowing the user to remove the nished printout.
ATTENTION!
While placing the IO BOX in the chamber, make sure you do not accidentally damage its components.
7. Unfold the IO BOX elements as much as possible. Inside the IO BOX you should see a covered Feed Bed and an
uncovered Print Bed.
8. Press REMOVE PRINTOUT and wait until the content of the Print Bed (the cake) is ejected.
9. Close the IO BOX.
10. Carry the IO BOX and its contents onto the foldable tray from Dedicated Powder Tools
1
or on the PHS worktop
2
then press DONE on the screen.