10 | Page
THE FOLLOWING ELECTRIC INSTRUCTIONS ARE FOR CANADA
CUSTOMERS
CAUTION: Breaker must remain off until installation is complete.
SERIOUS
BODILY
INJURY OR DEATH COULD OCCUR IF YOU IGNORE THIS WARNING.
SioGreen products must be installed by a licensed and qualified electrician in
accordance with all applicable national, state, and local electrical codes
depending on country.
Before installing this product, ensure that the home has sufficient electrical
power available to handle the maximum amperage load of the applicable
model.
IMPORTANT NOTES:
These units will require 1 set of wire and ground (see wiring diagram), 1
electric breaker, and 2 jumper wires. Jumper wires will be pre-installed by the
manufacturer. DO NOT REMOVE THE JUMPER WIRES. Removing the jumper
wires will void the warranty.
Specifications by Model (CANADA)
NUMBER
KW
BREAKER
POWER
WIRE
Step 1: Remove cover of the water heater carefully and locate the electrical
disconnect breaker on the bottom left hand corner facing the unit.
Step 2: Use the correct wire gauge that meets all NEC or country of installation
guidelines based on the size of the breakers used to feed the unit and the
length of the wire run.
Step 3: Run the set of wires from the home’s main panel to the tankless water
heater. (See above chart for minimum wire size) This minimum wire size is
based on maximum of 50’ of length.
Step 4: A separate ground conductor is required for the incoming circuit.
To Next Page
Loading...
Need help?
General